Luckfox Ultra HAT V3
Community · Dev-board
Price: N/A
Specifications
| Specification | Value |
|---|---|
| Product status | DIY design [1] |
| LoRa chip | SX1262 [3] |
| Processor | External host [1] |
| Radio power | 1000 mW (30 dBm) [3] |
| Frequency bands | 902–928 MHz [3] |
| GPS | Unknown |
| Display type | None [2] |
| Display size | None |
| Display details | None [2] |
| Input | None [2] |
| Battery | No built-in battery [2] |
| Dedicated solar input | No [2] |
| Antenna | External [2] Connector: Unknown |
| IP rating | Unknown |
| Dimensions | Unknown |
| Weight | Unknown |
Software support
The software runs on the connected computer.
| Software | Support | Details |
|---|---|---|
| Meshtastic | Community [8] | Details
|
| MeshCore | Unsupported | — |
| UMSH | Unsupported [9] | — |
Build resources
Build it from the project documentation linked in Sources. Components and assembly are required.
Notes
V3 is a radio HAT for the Luckfox Lyra Ultra W, not a complete node; it uses meshtasticd on the external host.[1][5]
The V3 schematic identifies an E22P-915M30S supplied at 5 V.[2] Ebyte rates this fitted module at 30 dBm (1 W) with at least 5 V supply.[3] GPS/I2C headers are expansion only; no GNSS receiver is installed.[2] Meshtastic support follows the community Luckfox Ultra 1W configuration.[8]
Sources
- wehooper4 Luckfox Ultra HAT README
- Luckfox Ultra HAT V3 schematic
- Ebyte E22P-915M30S radio module specification
- wehooper4 Luckfox Ultra HAT checkout
- Meshtastic mPWRD-OS board support
- Luckfox Ultra HAT V3 meshtasticd configuration
- FCC grant for Ebyte E22P900M30S module
- Meshtastic firmware meshtasticd config for wehooper4 Luckfox Ultra 1W hat (support: community)
- UMSH hardware support list
- Luckfox Ultra Hat V3 schematic published (wehooper4 maker repository)
Last updated 2026-10-20