Spec5 MeshClip
SpecFive · Tracker
Price: $89.00[1]
Specifications
| Specification | Value |
|---|---|
| Product status | Active [1] |
| LoRa chip | SX1262 [1] |
| Processor | ESP32-S3 [1] |
| Radio power | Unknown |
| Frequency bands | 915 MHz [1] |
| GPS | Not supported [2] |
| Display type | OLED [2] |
| Display size | 0.49 in [2] |
| Display details | 0.49-inch 64×32 OLED [2] |
| Input | Unknown |
| Battery | No built-in battery [1] |
| Dedicated solar input | No [3] |
| Antenna | External [1] Connector: Unknown |
| IP rating | Unknown |
| Dimensions | 65 × 70 × 17 mm [1] |
| Weight | 50 g [1] |
Firmware support
| Firmware | Support | Details |
|---|---|---|
| Meshtastic | Official [4] | Details
Confirm your exact device in the official flasher before choosing a build. Meshtastic web flasher |
| MeshCore | Unsupported | — |
| UMSH | Unsupported | — |
Where to buy
| Vendor / configuration | Price | Based in | Ships from |
|---|---|---|---|
| SpecFive | |||
Tindie Meshtastic · 915 MHz | $89.00 Observed 2026-10-21 | 🇺🇸 | Unknown |
Notes
The seller identifies the installed radio board as Heltec Wireless Stick V3.[1] The device has no built-in battery; it can draw power from a compatible phone or an external power pack, neither included.[1] The board’s OLED is not used by Meshtastic, which Heltec says uses the Wireless Stick Lite V3 firmware.[4]
Sources
- SpecFive S5 MeshClip exact Tindie offer and product specification
- Heltec Wireless Stick V3 product specifications
- Heltec Wireless Stick V3 schematic
- Heltec Wireless Stick FAQ: firmware and display compatibility
- Meshtastic official Wireless Stick Lite V3 device documentation
Last updated 2026-10-21